T1 ToneMatch® Audio Engine / Digital Delay for Second L1®
Here are some notes on how to use your T1™ to drive a main L1™ at the front of the house and a second L1™ farther back. The goal is to provide sound in a long room, in this case approximately 50 feet wide by 250 feet long.
Contents
Terms
- Main L1™ is the one at the front of the house.
- Secondary L1™ is the one farther back.
Connections
T1™ Inputs
- 1 Microphone
- 2 Microphone / Instrument or Mixer
- 3 Used for Digital Delay processing
- 4/5 USB input from Computer
T1™ Outputs
- Tonemate™ (Ethercon Connection) goes to the Main L1&trade.
- Main ¼ inch output goes to Channel 3 input.
- Aux ¼ inch output goes to Secondary L1™ Analog Input
Turn down the Master Volume while making the following connections
Ordinary connections
Connect inputs for Channels 1, 2 and 4/5 in any way you like. Ensure that the setting for Aux is Mute for all.
Channel 3 – Turn level down, Ch 3 Mute
We are setting the Level to zero and we will not change this while using Channel 3 for Digital Delay processing. We are setting the Mute as an additional precaution.
Settings for Channel 3
- Turn on Channel 3 CH Edit
- Turn the main Selector to Digital Delay
Digital Delay – Mix and Time
Set the Mix to 100% and the Time to 100ms. We will fine tune the time setting by ear later.
Digital Delay – Fdbk (feedback)
- Press the third button to switch from Time to Fdbck.
- Rotate the button to set the Fdbk to 0%
Channel 3 Aux
- While still working with the CH 3 Edit lit turn the main selector to Aux.
- Set the Level to 100%
Aux – Tap Setting
- Press the Tap button and set it to Pre: With EQ & FX
Main Out (¼ inch) to Channel 3 Input
