Difference between revisions of "T8S to One L1 Model II"
m |
m (→Connect the T8S to {{Model II}}) |
||
| Line 11: | Line 11: | ||
== Connect the T8S to {{Model II}} == | == Connect the T8S to {{Model II}} == | ||
| + | === 1/4 inch (6.3 mm) Tip-Ring-Sleeve Output== | ||
[[File:T8S to L1 Model II x 1.png|600px]] | [[File:T8S to L1 Model II x 1.png|600px]] | ||
| Line 17: | Line 18: | ||
OR | OR | ||
| + | |||
| + | === XLR Output === | ||
[[File:T8S to L1 Model II x 1 XLR.png|600px]] | [[File:T8S to L1 Model II x 1 XLR.png|600px]] | ||
Revision as of 22:59, 12 March 2019
Introduction
Connect a T8S ToneMatch mixer to a single L1 Model II
Connect the ToneMatch Power Supply to the T8S ToneMatch mixer for power.
Connect the T8S to L1 Model II
= 1/4 inch (6.3 mm) Tip-Ring-Sleeve Output
The output from the T8S ToneMatch mixer is a balanced mono 1/4 inch (6.35 mm) Tip-Ring-Sleeve and the input on the L1 Model II is a balanced mono 1/4 inch (6.35 mm) Tip-Ring-Sleeve so use a cable like this.
.
1/4" TRS Balanced Patch Cable (audiopile.net)
OR
XLR Output
The output from the T8S is a balanced mono XLR and the input on the L1 Model II is a balanced mono 1/4 inch (6.35 mm) Tip-Ring-Sleeve so use a cable like this.
.
XLR Female to 1/4" Male TRS Cable
L1 Model II Analog Input
The Analog input is a ¼ inch balanced input jack.
Analog input trim (volume, or gain) control
Set the L1 Model II Analog Input trim control to match the output of the T8S ToneMatch mixer.
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the T8S ToneMatch mixer Main Output to the Analog Input
- Adjust the volume of the T8S ToneMatch mixer Main Output to the maximum output without distortion. This is probably between 10:00 o'clock and 12:00 o'clock on the Master Output
- While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.
