Difference between revisions of "Template:ToneMatch Power Supply"
m |
m |
||
| Line 20: | Line 20: | ||
Note: The picture is taken with the flat side facing the camera. The release clip is on the other side. | Note: The picture is taken with the flat side facing the camera. The release clip is on the other side. | ||
| − | [[Image:T1 Power Supply RJ 45 Connector.jpg| | + | [[Image:T1 Power Supply RJ 45 Connector.jpg|400px|Close up of the RJ45 connector]] |
| + | |||
---- | ---- | ||
Revision as of 23:35, 16 April 2020
ToneMatch® Audio Engine power supply. This is the power supply for the ToneMatch Mixer[1]. You will need this to power your ToneMatch Mixer[1] when running with an L1 Compact, S1 Pro System, L1 Classic, L1 Model I, or or non-Bose equipment. You will need a one of these if you have two ToneMatch Mixer[1]s running into a single L1® Model II or L1® Model 1S. — details below the picture.
Click image above for purchasing details.
If you connect your T1 ToneMatch® Audio Engine to a L1 Model II or L1 Model 1S then the T1 ToneMatch® Audio Engine draws its power through the ToneMatch® cable.
If you connect your T1 ToneMatch® Audio Engine to an an L1 Classic, L1 Model I or L1 Compact or non-Bose equipment then you will need the T1 ToneMatch® Audio Engine power supply
If you are attaching two T1 ToneMatch® Audio Engines to a single L1® Model II then you will need this power supply to support the second T1® - the one connected to the Power Stand Analog Input.
See: Connecting Two T1®s to a Model II for details.
Close up of the connector that goes to the ToneMatch Mixer[1], just in case you damage the cable and have to replace the connector.
Note: The picture is taken with the flat side facing the camera. The release clip is on the other side.
