Difference between revisions of "Mixer / Yamaha / MG124 CX"
m (→Documents) |
m (→Overview) |
||
| Line 11: | Line 11: | ||
* Run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below) | * Run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below) | ||
[[Image:YamahaMG124 to Model II Power Stand Analog Input.png]] | [[Image:YamahaMG124 to Model II Power Stand Analog Input.png]] | ||
| + | |||
| + | ==== Settings on the L1® Input Panel ==== | ||
| + | Start off with the Input Trim at '''3''' and adjust if necessary so that the Signal/OL light stays green most of the time. Occasional flickers of yellow are okay. If it is flickering or solid red, turn down the Input Trim. | ||
| + | |||
| + | [[Image:ModelIIInputsForTwoLT1.png]] | ||
==== Cable Details ==== | ==== Cable Details ==== | ||
Revision as of 13:01, 19 September 2012
| To use a Yamaha MG124 CX Mixer with the L1 Model II |
Overview
On the mixer
- Pan all the inputs hard LEFT
- Run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below)
Settings on the L1® Input Panel
Start off with the Input Trim at 3 and adjust if necessary so that the Signal/OL light stays green most of the time. Occasional flickers of yellow are okay. If it is flickering or solid red, turn down the Input Trim.
Cable Details
¼ inch jack inch to ¼ inch
|
This mixer has ¼ inch jack balanced outputs. Any of the cables shown below should work.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)The output of this mixer is balanced, and the input on the Model II Power Stand is also balanced, so this is the preferred method.
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
|
Documents
