Pedal Steel Guitar
Brian Terry provided this information about his settings with his Pedal Steel Guitar and his L1 Model II and T1 ToneMatch Audio Engine.
Hi guys, I did purchase L1® Model II with T1 ToneMatch® Audio Engine and I'm very impressed and as promised here are my settings I'm currently experimenting with, But PLEASE NOTE that I'm using a Peavey Profex 11 with Newmans, Larry Sasser Settings and Mullen S10 Royal Precision pedal Steel with Goodrich vol pedal So here goes
- Preset Rickenbaker 4001 bass
- ZEQ low 5.8 Mid 3.8 High 10.4
- Para EQ level 1.8 Freq 1.65 width2.07
- Comp Gate thresh .76 Speed 50%
- Delay Digital Mix 19% Time 57 ms
- Reverb Mix 19% Bright 91%
- Reverb Type Medium Room Time 1.7 Bal 50%
Regards Brian Terry
Original post Bose amp System for Pedal Steel Guitar
Notes from Len Imbery
I've run across a couple of people's Presets for using a pedal steel guitar with a Bose L1 II (w 2 B1s). I've sort of played with the settings I've found and averaged them out and tweaked a bit and find that the following settings are at least a good starting point if you want to customize (or just leave it as that's what I happen to like.
Preset Rickenbacker Bass 4001 ZEQ low 10.4 mid 2.6 high 3.8 Para eq level 5.4 freq 1609 width 1.14 compression 1 thresh -18.5 gain 13.8 modulation chorus 2 mix 37% depth 48 delay type digital mix 18% time 319.2ms reverb mix 41% bright 50% rev type medium time 1.70 balance 50%
Original post Pedal Steel Guitar Preset