Mixer / Mackie / 1604-VLZ

Classic

L1 Model I

Mackie 1604-VLZ

Summary

You can use ¼ inch phone jacks

Use ¼ inch phone jack (Tip-Sleeve) outputs 27 to

• The PS1 Power Stand (Classic) / Model I Channels 1 or 2 if you want to use the Presets and the R1 Remote Tone and Level Controls.

OR

• The PS1 Power Stand (Classic) / Model I Channels 3 or 4 if you prefer to leave Channels 1 or 2 open for other inputs. You will have to control Tone and relative Level (between the Channels) at your input source, as you do not have this control over Channels 3 and 4 in the PS1 Power Stand (Classic) / Model I or the R1 Remote.
• You can also use output 28 and run a single output to the PS1 Power Stand (Classic) / Model I.

You can use TS (Tip Sleeve) unbalanced cables, or TRS (Tip Ring Sleeve) balanced cables, but since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables.

¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)

This should work fine.

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)

This should work fine.

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)

This should also work, but likely no better than a simple ¼ Inch Tip-Sleeve to Tip-Sleeve cable. This is because the ¼ Inch input on the Bose System is Tip-Sleeve (unbalanced) anyway.

Tip Sleeve connections

Excerpt from page 15 of the the Mackie 1604 VLZ Manual .

Note: The general description of connecting to a house amplifier is applicable (and in our case is the connection to the PS1 Power Stand (Classic) / Model I. The highlighted section (green) is applicable to the PS1 Power Stand (Classic) / Model I because the PS1 ¼ inputs are unbalanced.

Mono Output

Excerpt from page 15 of the the Mackie 1604 VLZ Manual

Links

• Mackie 1604 VLZ Manual

---