Preset for Double Bass with Schertler DYN-B

From Bose Portable PA Encyclopedia
Revision as of 03:58, 18 February 2008 by ST (talk | contribs) (T1 Cross reference)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Classic This information is applicable to the L1® Classic
L1 Model I This information is applicable to the L1 Model I

Quoting Monte from the Bose® Pro Portable PA Community

... #60 has been good to me but I have to drastically cut the mids on the remote. Sounds pretty great until it gets loud, and then the bass gets a little hollow. I ended up using #83 with the band pass, and instant great acoustic sound!! I ran flat on the eq and the sound was hands down the best live sound I have ever gotten.
At the end of the night some of the guys from the Shoals were in and the keyboard and guitar turned up. The vocalist at the bar motioned I needed to turn up. Still sounded the same, but it was LOUD. Still sounded just like my bass sans amplification.
Unless anyone does an EQ setting for the SChERtLER Dyn family (Hint?!?) this one works really well for me. It was actually better than using channel 3 with my dedicated Schertler acoustic preamp.

Original Post


  • Presets 2.0 mentioned above
    • 60 Upright 3/4 Bass w/ Fishman pickup Basses
    • 83 50 Hz / 5 KHz Band Pass Utility
  • T1 ToneMatch Audio Engine Preset equivalent to #83 above
    Category: Utility
    Preset: 50HZ-5kHz Bandpass