Search results
Create the page "Balanced" on this wiki! See also the search results found.
- # Using a Balanced cable from the Aux Out to the Rolls, gave signal in both ears! Nice.1 KB (255 words) - 04:48, 26 March 2017
- [[Image:XLR Male to TRS.jpg|200px|TRS Male to XLR Male balanced cable]]248 bytes (40 words) - 15:11, 13 March 2008
- ...nected and it will reduce the bass output level and the sound will now be "balanced".5 KB (774 words) - 16:10, 28 April 2023
- * Balanced XLR audio output for Microphone or Line level signals and a 1/4-inch line l4 KB (614 words) - 14:24, 11 March 2020
- I still use my Taylor for recording as it is a little more balanced when mic'd. The CA has a little more of a tinkly bell sound on the upper re3 KB (547 words) - 14:39, 11 March 2019
- ...nice sustain. The low "E" strings is about as deep as they can be and very balanced with the others. The unplugged volume is about the same as the wooden count2 KB (301 words) - 02:59, 16 January 2009
- ...real good but far away” VDrums “not as dynamic, could be louder, not balanced within the instrument (toms, snare, etc)”34 KB (6,140 words) - 03:49, 24 February 2010
- ...Simultaneous outputs let the amp drive any combination of stereo speaker, balanced recording and slave amp outputs. The speaker outputs can handle 4 or 8 ohm34 KB (5,610 words) - 15:00, 18 January 2021
- :*Convert the signal to mono and if the output is balanced, use a 1/4 inch (6.3 mm) Tip-Ring-Sleeve or XLR to 1/4 inch (6.3 mm) Tip-Ri4 KB (640 words) - 19:22, 20 February 2024
- Output impedance at 1kHz (balanced) (1/2 ± 20%): 1502 KB (329 words) - 19:35, 21 July 2021
- The analog input on the Model II is balanced, and will therefore subtract the Left and Right signals on a stereo cable a2 KB (292 words) - 19:32, 30 September 2019
- The guitar had a strong, well-balanced sound. It was, as Jean15 KB (1,966 words) - 05:52, 26 March 2017
- The Power Stand for the {{Classic}}, {{Model I}} and {{Model II}} have a balanced ¼ inch jack line out for bass expansion. See the links below for det1 KB (162 words) - 13:49, 28 May 2019
- ...eMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members|Balanced}}1 KB (190 words) - 14:49, 14 August 2019
- ...to perfectly fall under the string – This translates into extremely well balanced pickups without dead areas and hotspots, particularly on large string bends6 KB (926 words) - 18:46, 26 March 2017
- <table><tr><td>Balanced ¼ inch jack Tip-Ring-Sleeve cable</td><td> or </td><td>Unbalanced &f4 KB (655 words) - 22:53, 28 March 2017
- ...ll with LRBaggs Element for Nylon String. The sound was immediately warm, balanced, and completely hum-free - I could play at high sound pressure levels with6 KB (1,079 words) - 02:22, 27 December 2014
- {{:Balanced vs Unbalanced}}27 bytes (3 words) - 11:03, 19 March 2015
- Individual outputs that provide balanced line output signals (pre-volume control) that can be sent to powered louds20 KB (3,211 words) - 12:46, 29 September 2023
- ...pendent of the Master volume. This is why you want to set it to be equally balanced with the Master. You will then be able to control the balance and level fro5 KB (809 words) - 17:12, 26 December 2017
- <table><tr><td>Balanced ¼ inch jack Tip-Ring-Sleeve cable</td><td> or </td><td>Unbalanced &f5 KB (825 words) - 04:27, 26 March 2017
- ...eMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members|Balanced}}7 KB (1,177 words) - 04:14, 26 March 2017
- ...connections. You can use ordinary instrument cables. They don't have to be balanced.2 KB (443 words) - 22:23, 16 November 2019
- {{Balanced Unbalanced 1/4}}740 bytes (132 words) - 22:24, 16 November 2019
- The MAIN outputs from this mixer are balanced, 1/4 inch (6mm) Tip-Ring-Sleeve connections.1 KB (243 words) - 22:25, 16 November 2019
- The {{T1}} Aux Out is a 1/4 inch (6 mm) Tip-Ring-Sleeve balanced mono output and it is suitable to connect to the {{S1}} Channel 1 or 2.659 bytes (111 words) - 22:19, 16 November 2019
- {{Balanced TRS from T8S to F1}}1 KB (183 words) - 04:21, 27 December 2018
- ...odel I are unbalanced. That means, there's no need or advantage to using a balanced Tip-Ring-Sleeve cable. Also, if you use a 1/4" Tip-Ring-Sleeve to XLR cable1 KB (228 words) - 22:20, 16 November 2019
- {{Balanced TRS from S1 to Model II}}1 KB (213 words) - 22:23, 16 November 2019
- {{Balanced TRS from T8S to L1 Model II}}1 KB (198 words) - 21:40, 22 November 2020
- :The S1 Pro system is engineered to deliver great balanced sound without a separate bass module. It doesn't have an extra amplifier bu2 KB (308 words) - 15:44, 19 May 2022
- The {{T1}} Master Out is a 1/4 inch (6.3 mm) Tip-Ring-Sleeve balanced mono output and it is suitable to connect to the {{S1}} Channel 1 or 2.831 bytes (134 words) - 22:25, 16 November 2019
- {{Balanced TRS from T1 to T8S}}2 KB (333 words) - 11:04, 8 April 2019
- :The S1 Pro system is engineered to deliver great balanced sound without a separate bass module. It doesn't have an extra amplifier bu2 KB (274 words) - 22:20, 16 November 2019
- XLR cable connection (balanced). This is preferred for connections longer than 20 feet (6 meters).2 KB (248 words) - 22:21, 16 November 2019
- * Use balanced cables682 bytes (115 words) - 03:41, 23 August 2019
- ...or a [[Balanced_vs_Unbalanced#Balanced_Connections_Preferred_When_Possible|balanced connection]]3 KB (441 words) - 20:35, 8 December 2021
- {{1/4 TRS Balanced}}3 KB (471 words) - 21:37, 3 September 2021
- * I have a snake with the power cable and a balanced cable for the line out3 KB (556 words) - 17:43, 20 June 2023
- If the mixer has 1/4-inch (6.3 mm) Tip-Ring-Sleeve (balanced) outputs, use 1/4-inch (6.3 mm) Tip-Ring-Sleeve cables to connect to the L4 KB (677 words) - 00:26, 29 February 2024
- ...nds fine on its own. It’s one of the various electric guitars that sound balanced when recorded “direct”. Others like this include the Gibson Les Paul an16 KB (2,852 words) - 09:17, 25 March 2024