Search results
Create the page "Microphone" on this wiki! See also the search results found.
Page title matches
- #REDIRECT [[Microphone Polar Pattern]]38 bytes (4 words) - 18:26, 10 September 2022
Page text matches
- ...necting a piece of equipment with an electronic audio output to a standard microphone or line level input. It performs both level and impedance matching to minim ...impedance suitable for feeding down a long multicore to a mixing desk’s microphone input. A low impedance enables long cable runs, with very little quality lo4 KB (608 words) - 15:46, 23 January 2013
- ...sure level that can be attained before the sound from a speaker enters the microphone and is amplified a second time, creating a loop that only builds on itself: ...of how loud a sound reinforcement system can be turned up before any open microphone(s) will feed back. The point at which feedback occurs is effected by numero991 bytes (142 words) - 00:29, 28 June 2018
- ...itional guitar amplifier. These guitarists can use a tube amplifier with a microphone in front of the amplifier. Exceptional results have been obtained with the ...II system<nowiki>’</nowiki>s analog input. However, in this instance, a microphone cable must be used in conjunction with a direct box or a transformer to ada42 KB (6,832 words) - 05:25, 26 March 2017
- ...ypass]]). If you are using a {{Compact}} channel 1, you cannot bypass the microphone Preset.1 KB (227 words) - 00:17, 23 December 2014
- ;Question: How do I remove the popping sound when I say "P"s and "B"s into my microphone. Shure SM58 ...at you have excessive popping for breath blasts, you should try moving the microphone closer, farther away, or placing at the corner of your mouth so it is not i1 KB (202 words) - 16:43, 4 July 2018
- * Microphone :Sing directly into the microphone using close microphone technique (lips just brushing the windscreen). Sing as loudly as you will s3 KB (508 words) - 06:27, 22 December 2018
- {{T1 Gain Microphone}} {{Get Plugged In Microphone}}7 KB (1,267 words) - 00:54, 30 November 2016
- * Microphone (s) * 1 XLR for Microphone3 KB (524 words) - 00:28, 23 December 2008
- ...o microphones will get equally but out-of-phase so it cancels when the two microphone signals are summed together. In essence it creates a "blind spot" for the m You will need to swap the wires on 2 and 3 on one of the ends that goes to a microphone.6 KB (927 words) - 15:30, 22 December 2008
- == Microphone Directionality ==2 KB (312 words) - 16:08, 18 June 2016
- This is the same kind of cable you would use to connect a microphone. The XLR inputs for Channels 1 and 2 are intended for microphone level inputs. <br>4 KB (558 words) - 06:14, 3 February 2015
- * Run your microphone into the first {{l1 nl}} PS1 Powerstand (let's say - Channel 1). * Choose the best preset for your microphone.3 KB (488 words) - 10:45, 26 May 2011
- ...vel of a kick drum channel while eliminating the risk of feedback from the microphone. # Connect the appropriate type of microphone.4 KB (718 words) - 04:48, 26 March 2017
- - There are far fewer feedback loops because a microphone is connected to only one Cylindrical Radiator® speaker, not many as in the ...drical Radiator speaker (little level change with distance) you can move a microphone around with much less fear of triggering feedback.2 KB (406 words) - 18:13, 26 March 2017
- === Open Microphone on the Kick Drum ===4 KB (800 words) - 03:03, 29 October 2007
- * 1 Microphone * 2 Microphone / Instrument or Mixer12 KB (2,012 words) - 10:58, 5 January 2023
- ...e I got there. All I did was suggest some different Presets to try for the microphone on his acoustic Guitar. Then I got as far as telling him about the Scenes, ...a Scene. Just an aside, he runs his Guitar with a pickup and then likes a microphone on stage with all the low end cut out, and the gain relatively low so that9 KB (1,752 words) - 19:00, 4 January 2009
- ...ll hear what is plugged into the input of each channel, whether it’s a microphone, iPod, guitar, etc. * Microphone / instrument -> T1 -> T1 AUX out -> Zoom H4 Recorder (L or R input)10 KB (1,768 words) - 14:28, 11 March 2019
- ...y into the L1 Model 1S system's analog input. However, in this instance, a microphone cable must be used in conjunction with a direct box or a transformer to ada <li>ToneMatch audio engine microphone stand bracket (PC 042535)</li>14 KB (2,381 words) - 05:47, 26 March 2017
- Connecting the TC-Helicon Harmony G-XT microphone output to the L1® Compact Channel 1. ...one Preset]]. As a result you ''may'' experience a greater tendency toward microphone feedback when using the '''Tone''' feature. You can overcome this by turni942 bytes (126 words) - 13:34, 29 May 2014