Search results

Jump to: navigation, search

Create the page "Insert" on this wiki! See also the search results found.

Page title matches

Page text matches

  • Effects for the PS1 Powerstand
    [[Image:PS1InsertPoints.png|550px|right|Powerstand Insert Point]] ...y simply use the insert jack on the {{PS1}} . You probably will need an “insert” cable that has one [[TRS]] (stereo) 1/4” connector on one side and 2 m
    4 KB (675 words) - 11:34, 8 July 2010
  • L1® Model I / FAQ
    ...into channels 1 or 2 of the power stand. These connectors require standard insert cables with 1/4" TRS connections on one end and dual male 1/4" TS connector === How do I know which half of the Cylindrical Radiator® to insert into the power stand first? ===
    60 KB (9,859 words) - 05:33, 26 March 2017
  • R1 Remote
    ...signal has been reached at a point '''after the preamp''' and '''after the insert loop''' and '''before the conversion of the signal from analog to digital'' === LEDs and the Insert Loop ===
    11 KB (1,902 words) - 15:41, 23 April 2017
  • PS1 Powerstand/Effects/Serial
    === Insert Cable === {{:Insert Cable}}
    698 bytes (95 words) - 11:32, 8 July 2010
  • PS1 Powerstand Connections/Line Out/Insert
    == Line Out from Insert Point == * access from the "ring" connection at the Insert Point
    749 bytes (116 words) - 03:07, 29 April 2007
  • PS1 Powerstand Connections / Line Out
    === Insert Send === **Insert returns
    1 KB (150 words) - 10:39, 5 November 2010
  • Boss RC-30 Loop Station
    The INSERT point works really well with my Boss RC-30 Loop Station. I used a regular insert cable with the connections this way:
    1 KB (242 words) - 01:09, 28 March 2017
  • Effects PS1 Powerstand TRS Connections
    ...sert Cables are labelled. '''This''' is how the connections are run at the Insert Point of the PS1 Powerstand. and this is connected to '''one''' of the PS1 Powerstand Insert Points
    448 bytes (66 words) - 00:39, 4 January 2007
  • Effect / Alesis / MidiVerb4
    You will need one Insert Cable {{:Insert Cable}}
    935 bytes (127 words) - 18:34, 23 June 2009
  • TC Electronic G-Force
    ...PARAMETER WHEEL to select the position where you wish to insert an effect and select which block to insert using the VALUE wheel. Route in serial or parallel,
    30 KB (3,215 words) - 13:19, 12 November 2008
  • Half Insert
    ...an half-insert a normal 1/4" plug into the {{PS1}} insert jack (that means insert to the first “click” but not all the way) and connect that to the input
    457 bytes (81 words) - 18:48, 6 November 2006
  • Insert Cable
    <!-- to be used as an inclusion when mentioning insert cables --> Typical Insert Cable [http://www.sweetwater.com/store/detail/STP204/ Hosa STP204]
    198 bytes (31 words) - 12:20, 18 December 2006
  • L1® Model II / FAQ
    === How do I know which half of the Cylindrical Radiator® to insert into the power stand first? ===
    42 KB (6,832 words) - 05:25, 26 March 2017
  • Balanced vs Unbalanced
    ...1/4 inch (6.3 mm) Tip-Ring-Sleeve to XLR]][[File:14 insert.jpg|thumb|100px|Insert cable]] * Insert (send and return)
    8 KB (1,267 words) - 17:43, 7 February 2023
  • L1 Cylindrical Radiator® loudspeaker
    * Be careful how you insert the lower section. If you insert it upside down you may damage the connector in the Power Stand.
    12 KB (2,008 words) - 06:55, 26 March 2017
  • Pad
    An inline pad can be easily soldered, you'll need to insert 3 resistors into your mic cable. The values of these three resistors are de To build a -20dB attenuation pad insert the following three resistors into your XLR cable path.
    5 KB (853 words) - 17:26, 14 May 2017
  • Troubleshooting
    ...c}} or {{Model I}} remove anything connected to the Channel 1 or Channel 2 insert points. ** Make sure input sources are NOT plugged into Channel 1 or Channel 2 '''Insert''' points
    7 KB (1,133 words) - 16:32, 13 October 2010
  • Presets 2 Upgrade instructions
    # Insert the CD #1 DSP Software Update 1.84 disc into the DVD player. Press the STOP # Insert the CD #2 Presets 2.0 Update disc into the DVD player. Press the STOP butto
    7 KB (1,127 words) - 15:32, 1 November 2016
  • PS1 Powerstand/ Preventing Incorrect Connections
    ...ng setup (such as putting a 1/4 intended for channel 4 into the channel 2 "Insert" socket, or plugging the B1 cable into Amp 2 output) - particularly during ...e door wouldn't close (the closed door comes really close to the channel 2 insert socket).
    2 KB (377 words) - 23:26, 15 August 2007
  • Peavey Kosmos® Pro
    Setup: Used the Insert connector on the PS1 to route through the main in/out in the Kosmos Pro. ...udio directly into the PS1s, channel 1, using 00 preset. Use the channel's INSERT connector to connect to the Kosmos' main I/O. Don't use the Kosmos' subwoof
    6 KB (957 words) - 18:38, 26 March 2017
  • Securing the T1® to the Microphone Stand Bracket
    # Then I insert the ToneMatch cable into the T1®. It locks into place. #I insert all the other cables into the T1® before I put it on the bracket. I do it
    2 KB (397 words) - 05:11, 26 March 2017
  • Bose T4S and T8S ToneMatch® Mixers Compared to Bose T1® ToneMatch Audio Engine
    * 6mm (1/4"-20) threaded insert at the bottom for use with mounting hardware, ...Radiator® stand and the mic stand adapter (replaced by the common 1/4"-20 insert)
    3 KB (453 words) - 01:38, 17 May 2021
  • L1® Unofficial Performers' Guide
    * Make sure the Speakon cables (blue) are really connected. Insert and turn clockwise. There should be an audible click. You should have to sl
    12 KB (2,071 words) - 02:57, 26 March 2017
  • Sandbox
    # Insert the L1&trade; Cylindrical Radiator sections
    9 KB (1,320 words) - 05:36, 25 November 2018
  • Steve's Tips and Tricks
    ...gets “thumped” and a knob is hard to turn, you can pull it off and re-insert the knob. What’s happening is the bottom of the knob is rubbing on the co
    3 KB (623 words) - 00:30, 23 December 2008
  • Mixer / Yamaha / MG8/2FX
    CH INSERT OUT (1 – 2) 150 Ω 10 kΩ Lines 0 dBu (0.775 V) +20 dBu (7.75 V) Pho
    1 KB (216 words) - 03:22, 21 December 2008
  • Effect / Alesis / NanoVerb
    Note - you will need an INSERT cable for each Bose Channel you want to run through your effects unit. (up
    1 KB (206 words) - 18:33, 23 June 2009
  • Effect / Alesis / PicoVerb
    Note - you will need an INSERT cable for each Bose Channel you want to run through your effects unit. (up
    1 KB (207 words) - 18:34, 23 June 2009
  • Effects/TC-Helicon/VoiceLive
    <big>''' TC-Helicon VoiceLive (Insert Method) '''</big>
    1 KB (191 words) - 19:12, 22 January 2007
  • Wiki Team
    ...comments with four tilde symbols <nowiki>~~~~</nowiki> and the system will insert your name, date and time.
    6 KB (1,039 words) - 19:36, 22 December 2008
  • Making a Living with the L1®
    ...a melody, not with a fully-produced, full-production music track that you insert your-lyric-here into. My children, some of them musicians but all of them
    27 KB (4,639 words) - 18:37, 26 March 2017
  • PS1 Powerstand / Signal Flow
    # Insert Loop
    2 KB (295 words) - 16:43, 12 January 2012
  • Effects/Fostex/DE-1
    ...- If you want to use two effects channels with the DE-1 you will need an INSERT cable for each Bose Channel you want to run through your effects unit. (up
    1 KB (171 words) - 13:39, 26 December 2006
  • Classic Extended Bass Package
    <div style="color:red; weight:bold;">DO NOT Connect/Insert the Cylindrical Radiator Loudspeaker into the PS1 Powerstand</div>
    2 KB (262 words) - 00:12, 7 December 2008
  • T1 ToneMatch® Audio Engine / Aux
    ...s that are specific to a channel (normally these would be connected to the insert loop of this channel). The "shared" effects typically come into the board t
    5 KB (923 words) - 20:02, 9 July 2018
  • Reducing Bleedthrough from Guitar to Vocal Microphone
    ...www.tc-helicon.com/VoiceLive TC Helicon Voicelive] ( for harmonies ) as an insert on the vocal channel. So, I used it to add compression to the vocal channel
    5 KB (851 words) - 11:19, 19 September 2008
  • Presets 3.0 Upgrade Instructions / Burning the CD
    # Insert a blank CD, and click the "Start Burn" button in Windows Media Player. Your
    4 KB (654 words) - 12:22, 29 December 2007
  • Gig Report / House Concert Fundraiser
    ...ir” in the sound. We ended up using an AKG C1000s with the hypercardioid insert for this.
    9 KB (1,752 words) - 19:00, 4 January 2009
  • Is It Too Expensive?
    ...rument (Channels 1 and 2). There are also two routing options for effects (Insert Point for serial effects and a separate return for parallel effects). There
    16 KB (2,913 words) - 11:43, 9 May 2011
  • Wikipedia:Template documentation
    Insert the documentation after the top line, and categories and interwikis under t
    8 KB (1,197 words) - 01:33, 30 March 2008
  • McIntyre BluesMaker II
    <td class="content"><p>Set SYSTEM: MODES: SEND BYPASS to Insert Mute in the MPX G2.<br>
    34 KB (5,610 words) - 15:00, 18 January 2021
  • T1 ToneMatch® Audio Engine / Routing for Effects
    ...an work with an external effects unit see: [[T1 ToneMatch® Audio Engine / Insert for External Effects]]
    3 KB (469 words) - 04:54, 26 March 2017
  • Compact Extensions Sticking
    ...4/m/743103812 original discussion: Compact Extensions Getting Difficult to Insert]
    1 KB (171 words) - 20:14, 2 May 2021
  • Audiopile: Cables for the L1® Family of Products / Review
    ...e part that activates the switch inside. It slides into the body when you insert it into your instrument.
    12 KB (2,058 words) - 05:45, 26 March 2017
  • T1 ToneMatch® Audio Engine / Insert for External Effects
    #REDIRECT [[T1 ToneMatch® Audio Engine / Insert for External Effects]]
    71 bytes (9 words) - 04:48, 26 March 2017
  • S1 Pro system
    When you insert a 1/8" (3.5 mm) jack in the Aux input, this disables streaming Bluetooth.
    14 KB (2,204 words) - 22:04, 15 September 2021
  • PS1 Powerstand
    ...vents are above the mixer section and if the bag is open enough so you an insert any cables, than its also open enough to get appropriate ventilation.
    6 KB (1,016 words) - 17:18, 26 February 2024

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)

Retrieved from "https://toonz.ca/bose/wiki/index.php?title=Special:Search"